Safe Luxury

Home > Your Home Computers Safe Information > Your Home Computers Safe Knowledge Base > A problem has been detected and windows has been shut down to prevent damage to your computer?

A problem has been detected and windows has been shut down to prevent damage to your computer?

switched on my comp normally and found this message popping up all the time. A problem has been detected and windows has been shut down to prevent damage to your computer. If this is the first time you’ve seen this stop error screen, restart your computer. If this screen appears again, follow these steps: Disable or uninstall any anti-virus, disk defragmentation, or backup utilities. Check your hard drive configuration, and check for any updated drivers. Run CHKDSK /F to check for hard drive corruption, and then restart your computer. Technical information: *** STOP: 0x00000024 (0x00190203,0x811b8148,0xc0000102,0x00000000) i've tried restarting my comp both starting the computer in any safe mode or last good configuration. and it doesn't allow me to restart in any mode and just keeps on restarting. my comp is on windows xp home edition and I dont have the Windows xp cb/ boot disk. any help in fixing this problem and getting my comp to start up normally. would be greatly appreaciated

Public Comments

  1. Hi, This stop error means that your ntfs file system is corrupt (damage in the file system, bad hard drive data, corrupt SCSI or IDE drivers or a corrupt ntfs.sys file). So check pout this page which may be of some help :- http://www.geekswhoknow.com/articles/stop-0x00000024-0x0000024-0x24-ntfs-file-sys-error-code.htm Arnak
  2. hello, see if from the safe mode options you have safe mode with command prompt, try to start the system there, choose administrator as the user and and at the command line type: %systemroot%\system32\restore\rstrui.exe that command should get you to the system restore , go back on the restore point and see if this help, good luck
  3. Re: STOP 0x00000024 (0x00190203,0x8253a828,0xc0000102,0x00000000) -------------------------------------------------------------------------------- I fixed mine in an unconventional way. I took out my boot drive and used it as a slave on another computer. When it booted, it ran CHKDSK and fixed the errors. I put it back in my original computer and it booted fine.
Powered by Yahoo! Answers